What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 20.06.2025 02:03

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
What is lightning?
This is where this question deviates from being a 'generic' question, and becomes more specific.
the problem then depends on "how fast does the fuse operate?".
One is “what exactly is in a ‘surge protector’ ? ”
Because the load is inductive, the current lags the voltage.(by a bit).
An AC voltage/ current source, and an ac inductive load.
2024–10–14 [Omar Gharbi Omar Gharbi ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Why We Still Can't Find A Solar System Twin - IFLScience
I post the exact comment here.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Can a twin flame runner be happy in a karmic relationship?
a photo is worth a thousand words.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Edit 2024–10.
If you were president, how would you make America "great again?"
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
What are some mind-blowing facts about Michael Jackson?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
A fuse is a non-resetable over current circuit protector.
But… the neutral is now “floating” because of the 1 ohm resistance.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Barnstars:
How do I get a white man for a serious relationship?
One
The third is lightning and “how it gets conducted into a home.”
It also is a device that limits the change in current flow.
What are some best sources of great porn?
In schematic diagrams this is the symbol for a fuse:
but this device (an Inductor) … impedes the rapid changes in the current.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
What is your review of X-Men '97 season 1?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
A circuit breaker is similar, but is resettable.
This is where the MOV conducts again, and dissipated the energy.
(Dc diagram shown, AC is similar).
Here is a simplified AC power diagram.
This is 'the assistant's answer'
Upvotes:
At one ohm, the resistor has a maximum of 1 watt power.
What does a fuse do?
what exactly is a ‘surge’ protector?
[image of Common-mode choke]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
He then describes Rainy Season and Lightning.
There are two important concepts here.
This device then solves the entire problem.
He then describes the function of a fuse.
First Sentence:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
nine
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
It seems Mohan does not understand the difference between a comment and an Answer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
He then asserts :
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
But it can get overloaded, and no longer works.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
At least they know the answer if they wanted it.
eight
2024–10–16 [ OO OLAOYE OYEBODE ]
These devices are installed between the “hot” and “neutral” and protective ground.
There are three different concepts here that are getting confused.
[old diagram got deleted by accident]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The bolt then partially travels down the line to your home.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The other is “what does a “fuse” do?”
Now when you have a certain ac resistance, then a current flows in a loop.
but I think this circuit , shows a few more pieces.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
These are simplified answers to the original question, and does not change anything I wrote above.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
so, what happens?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
For this case there are devices called Metal oxide varistors (MOV).
This one hit behind the barn.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–10[John johnson John Johnson ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.